Skip to content
Lake Simcoe Garage Door Co.Request a visit
Open 24/7(249) 204-2005Call now
Two detached extension springs with hooked ends on a garage bench. — Extension Spring Replacement, South Wynhurst

Emergency Springs · South Wynhurst

Extension Spring Replacement in South Wynhurst

The opener groans on the way up and the door slams the last foot on the way down, hard enough to rattle the windows. The motor is the same one it always was; something in the springs has stopped doing its share.

Call now · open 24/7(249) 204-2005

Request a visit

Right now

Before the door is looked at

Call (249) 204-2005, open 24/7.

  1. When a spring breaks, the safe approach for the household is to leave the door where it is, keep people and vehicles clear, and avoid running the opener, which can damage the top section, the trolley or the gear drive.

  2. Pull the manual release only when the door is fully closed unless a technician asks otherwise; a door disconnected while partly open can move on its own if the springs are out of balance.

  3. Never drive a vehicle at a closed door to get out; the door collapses and the stored tension in the counterbalance is released. Use the release, the outside key release, or a technician.

In plain words

When one extension spring breaks, the other is replaced with it. The two springs were fitted together, have stretched the same number of times and have rusted in the same air, so the survivor is near the end of its life. More importantly, a door balances only when both sides pull equally; a new spring paired with a tired one lifts one corner ahead of the other and twists the door. Fitting a matched pair rated for the door's weight lets the technician set both sides to the same hook position and hand back a door that rises level and holds where it is left.

Sound familiar?

The opener groans on the way up and the door slams the last foot on the way down, hard enough to rattle the windows. The motor is the same one it always was; something in the springs has stopped doing its share.

How the visit goes

Extension Spring Replacement · South Wynhurst

How the visit goes

Illustrative garage doors scene — South Wynhurst
  1. 1

    Weighing the door

    Extension springs are chosen by the weight they are built to lift, so the door is weighed rather than guessed at. With the opener released and the springs disconnected or slack, the technician lowers the door onto a scale set on the floor under the bottom section and reads the figure. That number, together with the door's height, sets the spring rating and stretch length. The old springs are measured as a cross-check, but the scale wins if the two disagree, because a door can gain weight from new panels, insulation or a cladding added since the springs went on.

  2. 2

    Setting both sides to the same hole

    The initial tension is set with the door open and clamped, so the technician is adjusting slack springs rather than loaded ones. Each cable's S-hook is placed in a hole on the hanger, or its clip set to a mark, and the two sides are put at the same position. The cables are drawn to the same snugness so that neither corner of the door is being pulled ahead of the other. A level across the top section confirms the door is square in its tracks. Only when both sides read the same do the clamps come off and the door come down for its first balance check.

  3. 3

    The numbers that stay with the door

    Before leaving, the technician tells you what the door weighed, which spring rating and length went on, whether the pulleys and cables were renewed, and which hook position the cables were set to. Write it on a card by the opener or inside the door's manual. Extension springs are sold by rating and length, so the next set can be ordered from that card without weighing the door again, and a technician arriving later can see at a glance whether the door has been altered since. Add the date and roughly how many times a day the door is used; together those two facts give a fair idea of when the springs will be due again.

In the van

  • Rear spring hangers and angle iron
  • Track clamps or locking pliers
  • Containment (safety) cables
  • Pulleys (sheaves) and forks
  • Extension springs, matched pair

What affects the quote

  1. 1

    Weight added since the door went in

    Insulation panels, windows or a wood overlay fitted after the original springs mean a heavier rating than the old pair. The door is weighed and the quote reflects the door as it is now.

  2. 2

    Rollers, hinges and bottom brackets found worn

    Cracked roller wheels, split hinges or a bottom bracket rusted at the cable pin are pointed out during the inspection and offered as optional items, since the door is already open and secured.

  3. 3

    Track or section damage found on the way

    A bent horizontal track, a bracket pulled off the jamb or a top section twisted by running the opener on a broken spring is separate repair work, quoted on its own.

Same fees day, night or weekend.

Have it ready

Before you call · 0 / 3

(249) 204-2005

Extension Spring Replacement: questions

Advice · (249) 204-2005

How do you know which springs my door needs?

By weight. Extension springs are rated for the weight they lift, so the technician releases the opener and weighs the door on a scale, then matches that figure and the door's height to a spring rating and stretch length. The old springs are measured as a check on wire size, coil diameter and length. Where the two disagree, the scale decides, since doors gain weight from added insulation or panels.

Can I use the door as soon as the work is done?

Yes. The last steps of the visit are the balance test by hand, several full cycles under power and the opener's reversal checks, so the door is ready for normal use when the technician leaves. New springs need no settling period. It is worth running it yourself once or twice while the technician is still there, so you know what a properly balanced door sounds and feels like from now on.

Could I switch to torsion springs instead of replacing the extension ones?

Sometimes, and it is worth asking. A torsion system needs room above the door opening for its shaft and a header that can carry the spring bracket, which many older garages with a low ceiling simply lack; extension springs are there for that reason. Where the headroom exists, a conversion is a separate job with its own hardware and quote. The technician can tell you on the spot which route suits your garage.

York, Ontario

South Wynhurst information

Town
South Wynhurst, York, Ontario
In business
15 years
Hours
Open 24/7 · nights, weekends and holidays, same fees
Visits
On-site assessment preferred. Request a visit or call.

What the census means at the door

43%

Homes of every age. About 43% of homes in Georgina were built in 1980 or earlier, according to the 2021 Census.

Where houses span several decades, weatherproofing needs vary: older garages with uneven aprons need thicker bottom seals, newer ones mainly need cracked seal sections replaced. The technician looks at how the door meets the floor and the jambs and fits the seal that actually closes the gap.

83%

Mostly houses. Single-detached houses make up about 83% of homes in Georgina (2021 Census).

In neighbourhoods of detached homes the garage door usually faces the street and takes up much of the front of the house, so its condition shapes how the whole property looks. A straight, quiet, well-finished door is as much a part of the curb appeal as the front door.

Source: Statistics Canada, 2021 Census of Population

Open South Wynhurst in Google Maps

Open 24/7

Request a visit

The opener groans on the way up and the door slams the last foot on the way down, hard enough to rattle the windows.

Call now · open 24/7(249) 204-2005
  • On-site assessment preferred
  • Same fees day, night or weekend
  • 15 years in business