Skip to content
Lake Simcoe Garage Door Co.Request a visit
Open 24/7(249) 204-2005Call now
Gloved hands holding a bright cable and pliers gripping a frayed cable beside a garage-door track and pulley. — Garage Door Cable Replacement, Roches Point

Emergency Springs · Roches Point

Garage Door Cable Replacement in Roches Point

After years of slushy winters the cables look thinner near the bottom brackets, with rust streaks running down the door where they attach. The door still works, but the frayed wires catch your glove when you brush past.

Call now · open 24/7(249) 204-2005

Request a visit

Right now

Before the door is looked at

Call (249) 204-2005, open 24/7.

  1. Never run the opener on a door that is off its track or hanging crooked; every cycle drives the racked door harder into the rails and can pull the track from the wall or tear a hinge.

  2. Pull the manual release only when the door is fully closed unless a technician asks otherwise; a door disconnected while partly open can move on its own if the springs are out of balance.

In plain words

Which counterbalance your door has shapes the job. Torsion doors carry a spring on a shaft above the opening, and the cables wind onto grooved drums at each end; the technician winds the spring down with steel bars, swaps the cables, sets the drums and winds it back up. Extension doors, common on older detached garages, run the cables over pulleys beside the horizontal tracks with a spring stretched behind each; here the door is opened and clamped so the springs relax, then the cable is threaded, adjusted at its clip and checked against its containment cable. Either way, the service ends with a balanced door.

Sound familiar?

The door went up as usual this morning, then stopped a third of the way with one corner higher than the other. It is wedged at an angle in the opening, the opener is humming, and nothing you press will move it.

How the visit goes

Garage Door Cable Replacement · Roches Point

How the visit goes

Illustrative garage doors scene — Roches Point
  1. 1

    Track, rollers and the door itself

    The last part of the first look follows the door's path. The technician checks that the vertical tracks are plumb and evenly spaced from the door, that the curve into the horizontal run is smooth, and that the track brackets are tight to the jamb. Rollers are checked for cracked wheels and bent stems, hinges for splits, and the bottom section for a dent or bow from a vehicle. Any of these can rub a cable or hold one corner back, and each is easier to correct while the counterbalance is unloaded. If the door is off its track as well, that is set straight as part of the same work.

  2. 2

    Extension-spring doors: pulleys, clips and containment

    On a door with springs along the tracks, the new cable is threaded from the bottom bracket up over the pulley at the front of the horizontal track, back to the pulley on the end of the spring, and forward to the adjusting clip on the track hanger. The technician replaces a pulley whose wheel is grooved or whose bearing has seized, since that is often what wore the cable, and checks the S-hooks and sheave forks. Each side is set to the same clip position so the door hangs level. A containment cable is confirmed through the centre of each spring and added if the door was never fitted with one.

  3. 3

    A door that runs level and quiet

    The first thing you notice is a door that rises squarely, with both bottom corners leaving the floor together and the top section staying flat as it turns into the horizontal track. The bottom seal meets the slab along its whole length, so the draft and the strip of daylight at one corner are gone. The opener sounds calmer, because it is moving a balanced door rather than dragging a crooked one, and it stops reversing for no apparent reason. If you lift the door by hand with the opener released, it moves with light effort and holds where you leave it. That is what a correctly cabled door feels like.

In the van

  • Torsion springs and winding cones
  • Containment cables
  • Clevis pins and cotter pins
  • Galvanized aircraft-type lift cables
  • Bottom rollers and hinges

What affects the quote

  1. 1

    Opener adjustment afterwards

    A newly balanced door often needs the opener's travel limits and force settings reset and its reversing tested. That short adjustment is named in the quote when it is needed.

  2. 2

    Corrosion and seized fasteners

    Set screws and bracket bolts that have rusted solid take time to free or cut, and badly corroded hardware is replaced rather than reused, which shows in the parts list.

  3. 3

    Access to the spring shaft

    Shelving, storage or a low ceiling around the torsion shaft and drums slows the work. Clearing the area beforehand or a tighter working space both affect the time quoted.

Same fees day, night or weekend.

Have it ready

Before you call · 0 / 3

(249) 204-2005

Garage Door Cable Replacement: questions

Advice · (249) 204-2005

Will the springs be checked as part of cable work?

Always. Cables and springs are one system, and a spring that is weak, mismatched or wound short is a frequent reason a cable goes slack in the first place. The technician looks for breaks, measures the spring against the door weight, and confirms the correct number of turns when winding back. If a spring needs replacing, that is explained and offered as its own decision rather than folded in unannounced.

What information helps when I call?

Whether the door is sitting crooked, jammed partway or on the floor; whether you can see a cable hanging loose, frayed or wrapped around the shaft; whether there is a spring above the door or springs along the tracks; the door's rough height and whether it is a single or double; and what happened just before, such as the door coming down on something. A photo of the drum end and the bottom corner is useful.

Should I keep using the opener until the technician arrives?

It is better to leave the door where it is and use another way in and out. Running the opener against a crooked or cable-slack door tends to tangle the cable further, twist the top section and knock the door out of its track, which adds to the repair. Pull nothing and adjust nothing; simply keep the opening clear and let the technician take it from there.

York, Ontario

Roches Point information

Town
Roches Point, York, Ontario
In business
15 years
Hours
Open 24/7 · nights, weekends and holidays, same fees
Visits
On-site assessment preferred. Request a visit or call.

What the census means at the door

43%

Homes of every age. About 43% of homes in Georgina were built in 1980 or earlier, according to the 2021 Census.

Mixed neighbourhoods often include renovated older houses with a new facade and a garage door that no longer suits it. Choosing a door that ties the renovation together, then installing it plumb and balanced in an older opening, is work we do regularly and enjoy.

83%

Mostly houses. Single-detached houses make up about 83% of homes in Georgina (2021 Census).

Detached houses commonly have attached two-car garages with a wide double door, which is a heavy door on a pair of torsion springs. Spring and cable work on these doors is done as a matched set so the door lifts level and the opener carries only its intended load.

Source: Statistics Canada, 2021 Census of Population

Open Roches Point in Google Maps

Open 24/7

Request a visit

After years of slushy winters the cables look thinner near the bottom brackets, with rust streaks running down the door where they attach.

Call now · open 24/7(249) 204-2005
  • On-site assessment preferred
  • Same fees day, night or weekend
  • 15 years in business